The rule of colour
Red lights are stop-now warnings: oil pressure, coolant temperature, brake system, battery charging, power steering. Pull over safely and switch off. Amber means something needs attention soon, and you can usually drive to a garage rather than a hard shoulder. Green and blue are information — lights on, cruise active, main beam engaged.
The single most expensive mistake drivers make is treating an amber light as decoration. A misfire left for a month can destroy a catalytic converter; a DPF light ignored long enough becomes a filter nobody can save.
Oil pressure — the one to obey instantly
If the oil can symbol lights up while driving, stop as soon as it is safe. It means oil pressure has dropped, not that the level is slightly low. Continuing to drive can destroy bearings in minutes, and the difference between pulling over and driving two miles is regularly the difference between a sensor and an engine.
Engine management light — steady versus flashing
A steady engine light means the engine management system has logged a fault. It may be something trivial like a loose fuel cap or a sensor, and it will not fail immediately, but it needs reading.
A flashing engine light is different: it usually indicates a misfire serious enough to send unburnt fuel into the exhaust, which can wreck the catalytic converter within a short drive. Reduce speed, avoid hard acceleration, and get it looked at the same day.
ABS, ESP and tyre pressure
An ABS light on its own means the anti-lock braking is disabled but conventional braking still works — you will stop, just without the safety net on a slippery surface. It is normally a wheel speed sensor, which is a modest repair.
An ESP or traction light that stays on is worth attention because it can indicate a steering angle or yaw sensor fault. A tyre pressure light is often just a slow puncture — check the pressures with a gauge before assuming a sensor failure.
What to do before you call
Note when the light appears: cold start, after twenty minutes, only when braking, only on full lock. That single detail often narrows diagnosis from hours to minutes — and it is the first thing a technician will ask you.
If you have a code reader, bring the codes. Do not clear them. Cleared codes erase the freeze-frame data that tells us what the engine was doing when the fault occurred, which is often the most useful evidence there is.
